Coral Industries 7000 Swing Door - 640 - Manual (Page 4)

640 (70A) 7/09
The use of a caulking compound will assure
a water-tight seal of your enclosure. Apply
caulk along outside edge of enclosure
where metal and shower meet, especially
where sill meets threshold. If desired,
caulk inside of enclosure where jambs
meet walls.
Caulk joint on sill where magnetic door
stop and sill meet. On opposite side,
caulk where hinge door stop and sill meet.
Caulk
Magnetic
Door Stop
Clean bottom channel of door before mounting
drip rail. After mounting, do not remove or
reposition. Allow 72 hours curing time for
maximum bond.
Drip rail may be additionally secured using 8A x 3/8" truss head screws. When drilling in door panel, make certain drill
does not hit glass. Glass is seated approximately 1/2" into channel.
Position drip rail on inside surface of door panel as
described below:
• Side-to-side placement: Edge of drip rail should be
flush with edge of door panel on hinge side of door.
• Vertical placement: Drip rail sweep should extend 1/2"
below bottom of door panel on opening side. Angle drip
rail so that sweep extends 3/4" below bottom of door
panel on hinge side. This will create an 1/4" slope from
opening to hinge side for water drainage.
Mark position. Remove drip rail from door. Peel protective
cover from tape, and press into place. Insert drip rail
plug (L) into groove of drip rail on opening side of door.
Sill
Jamb
From inside shower, measure width of door panel at
bottom. Drip rail (D) should be 1/2" shorter than door
panel width. If longer, cut to proper length.
Slide drip rail sweep into slot on back of drip rail. Trim
ends even with edges of drip rail. Smooth cut end of drip
rail fin with a file to remove sharp point.
Drip Rail
Sweep
INSIDE
OF SHOWER
Measure
D
Drip Rail
Contour
8 Drip Rail
(D)
9 Drip Rail
(D)
10 Caulking
Mount pull handles, from pull handle kit (H), using
6-32 x 1 1/4" pan head screws provided. Screw heads
should be on the inside of shower.
6-32 x 1 1/4" Pan
Head Screw
Interior Handle
Exterior
Handle
OUTSIDE OF
SHOWER
H
Pull
Handle
Kit
Handle for your door may be pre-installed. If so, disregard
this step and continue installation.
7 Pull Handle Kit
(H)
OUTSIDE OF SHOWER
Hinge
Door
Stop
Door
Panel
Sill
Caulk
640
L
D
Drip
Rail
INSIDE OF SHOWER
Drip Rail Plug
1/2"
1/4" drop from
Opening Side
to Hinge Side
for drainage
Door
Panel
Opening Side
Hinge Side
Drip rail flush
with edge of
Door Panel
Drip Rail Sweep
3/4"
Hinge Side
Caulk
Caulk
Jamb