Compaq 3000 Series - Manual (Page 23)

Regulatory and Safety Notices 2–1
2
Electrostatic Discharge
A discharge of static electricity from fingers or other electrostatic
conductors may damage electronic components. Before handling
electrostatic-sensitive components, discharge static electricity by
using one of the methods described in this chapter.
Preventing Electrostatic Discharge
Handling Drives
Before handling a drive, discharge static electricity by touching
an exterior unpainted metal surface of a device that is connected
to an electrical outlet by a grounding plug.
Do not touch the connector pins on a drive or the notebook.
Handling Internal Components
When you are removing or installing internal components, use the
following precautions:
■ Keep components in their electrostatic-safe containers until
you are ready to install them.
■ Have everything needed for the installation within reach so
that you do not need to leave the area after beginning the
procedure.
■ Use nonmagnetic tools.
307504-001.book Page 1 Thursday, August 29, 2002 9:28 AM