Coral Industries Steam Bypass - 2SR1-P (If Purchased from a Plumbing Wholesaler) - Manual (Page 6)

2SR1-P 7/05
Reposition one jamb on tub and mount to wall using
pan head screws (I) - 8A x 1 1/4 " pan head screws for
901 jambs, 8A x 2 1/4" pan head screws for 531
jambs.
Mount bumpers (H) in top and bottom holes.
8A x 1 1/4" or
8A x 2 1/4"
Pan Head Screw
B
Bumper
Jamb
Sill
A
Tub
OUTSIDE OF BATH
7 Jambs
(B)
/ Bumpers
(H)
Place one jamb (B) against wall, with bottom of jamb
resting on sill. If necessary for a smooth fit, file back
edge of jamb to fit contour of your unit.
Align jamb vertically using a level and mark wall through
prepunched holes. Remove jamb and repeat procedure
for remaining jamb on opposite side.
Drill where marked using 1/8" drill bit.
Jamb
Level
Sill
A
B
Mark wall through
prepunched holes
Centerline
OUTSIDE OF BATH
Tub
File to fit
contour
of unit
6 Jambs
(B)
For 901 jambs, short legs should be against wall.
For 531 jambs, long legs should be against wall.
When anchors (M) are used holes should be drilled
using 3/16" drill bit. (Use masonry bit for tile.)
I
H
Measure from wall to wall over the top of jamb and cut
header (C) to that measurement.
8 Header
(C)
Jamb B Header C
A Sill
Measure
OUTSIDE OF BATH