Drsx4450 installation instructions – Dataram DRSX4450 User Manual
Page 2
DRSX4450 INSTALLATION
INSTRUCTIONS
06705 B
2of 2
(continued from previous page)
MEMORY INSTALLATION
Note: Refer to your system owner’s manual for detailed instructions.
Removing the Top Cover:
The top cover and fan door are integrated.
•
Unlatch the fan module door.
•
Pull the two release tabs back to release the door.
•
Rotate the fan door to the open position and hold it there.
•
Press the top cover release button and slide the top cover toward the rear of the server the rear about a half-inch.
•
Lift up and remove the top cover.
•
Unpackage the FB-DIMMs and place them on an antistatic mat.
•
Ensure that the ejector tabs are in the open position.
•
Line up the FB-DIMM with the connector.
•
Align the FB-DIMM notch with the key in the connector. (This ensures that the FB-DIMM is oriented correctly).
•
Push the FB-DIMM into the connector until the ejector tabs lock the FB-DIMM in place.
If the FB-DIMM does not easily seat into the connector, verify that the orientation of the FB-DIMM is as shown in the figure below. If the orientation is
reversed, damage to the FB-DIMM might occur.
Dataram Customer Support
Dataram's Technical Support Program goes beyond the lifetime
warranty, routine calls and questions. As memory specialists since 1967,
we want to provide the most comprehensive level of service and support
in the industry.
Our Customer Support representatives can answer your questions and
give you information on system/memory configurations, upgrade options,
product specifications, compatibility and other technical topics or issues.
If a Dataram memory board does not function properly we will issue a
Return Material Authorization number (RMA#) for the return of the
defective module(s) and express ship a repair or replacement to you at
no charge.
In Europe:
+45 70 212 217 (Phone)
+45 70 212 216 (FAX)
[email protected] (E-mail)
In the U.S.A. and all other countries:
800-599-0071 (Toll Free)
609-799-0071 (Phone)
609-799-6734 (FAX)
[email protected] (E-mail)
Caution: If the top cover of the system is removed before the server
is powered off, the server will immediately go into Standby
mode.