Dave Smith Instruments TETRA - Manual (Page 30)

24
Mod Wheel Destination — Selects the destination to which the mod wheel is
routed. See Modulation Destinations on page 39 for a list of possible
destinations.
Press Amount: -127…+127 — Sets the maximum amount of modulation that
can be applied from MIDI Channel Pressure (aftertouch).
Press Destination — Selects the destination to which the Channel Pressure is
routed. See Modulation Destinations on page 39 for a list of possible
destinations.
Breath Amount: -127…+127 — Sets the maximum amount of modulation that
can be applied from MIDI Continuous Controller 2 (breath controller).
Breath Destination — Selects the destination to which the breath control is
routed. See Modulation Destinations on page 39 for a list of possible
destinations.
Veloc Amount: -127…+127 — Sets the maximum amount of modulation that
can be applied from MIDI note-on velocity.
Veloc Destination — Selects the destination to which the note-on velocity is
routed. See Modulation Destinations on page 41 for a list of possible
destinations.
Foot Amount: -127…+127 — Sets the maximum amount of modulation that can
be applied from MIDI Continuous Controller 4 (foot controller).
Foot Destination — Selects the destination to which the foot control is routed.
See Modulation Destinations on page 41 for a list of possible destinations.
Unison Parameters
Unison Mode: see table — Sets how voices are allocated and tuned when
unison is on.
Display Key mode
1 Voice Classic, two oscillator, monophonic mode
All Voices All available voices stacked in unison
AllDetune1-3 All available voices stacked in unison with
increasing levels of detuning among the
voices