Dave Smith Instruments MOPHO KEYBOARD - Manual (Page 24)

Envelopes
Mopho has three 5-stage (Delay + ADSR) envelope generators. Two are
dedicated—one to the filter and the other to the amplifier—and the third is
assignable to any modulation destination.
Envelope Select —Selects the envelope to edit. When all three are lighted, the
other envelope parameters control all three envelopes simultaneously.
Amount: -127...127 —Sets the amount of modulation from the envelope to the
destination: filter, amplifier, or the selected destination for envelope 3. The
modulation amount can be positive or negative, allowing for inverted envelope
control. (For the VCA, the range is 0-127, since you can't have a negative gain
on a VCA!)
Delay: 0...127 —Sets a delay between the time the envelope is gated on and
when the Attack portion actually begins
Attack: 0...127 —Sets the attack time of the selected envelope(s).
Decay: 0...127 —Sets the decay time of the selected envelope(s).
Sustain: 0...127 —Sets the sustain time of the selected envelope(s).
Release: 0...127 —Sets the release time of the selected envelope(s).
Velocity: 0...127 —Sets the amount of key velocity used to modulate the
envelope amount.
Other Envelope Parameters
There are two additional parameters for envelope 3 in the Miscellaneous
Parameters section.
Envelope 3 Destination —Sets the destination modulated by envelope 3. See
Modulation Destinations on page 33 for a list of possible destinations.
Envelope 3 Repeat: Off, On —When on, causes the delay, attack, decay, and
sustain portions of Envelope 3 to loop for as long as the envelope is gated on.
With repeat on, envelope 3 can even be used as a sort of complex LFO.
18