Dynojet 250i: Control Panel Interface Upgrade (S/N 201xxxx) - Manual (Page 15)

13
27. Re-Install the Stack Box support bracket with four ¼-20 x ½ -inch hex head bolts. Re-install the Stack
Box and secure with four ¼-20 x ½ -inch hex head bolts.
28. Connect the P/N 76950403 Air Pump cable to P11 on the Control Panel Interface front side and route
the cable out the rear hole on the Control Panel Interface to the back of the dyno.
P11 Air
Pump supply
Support Bracket