Dynojet 250iPX: Installation Guide User Manual
Page 33
Advertising

M O D E L 2 0 0 I P X / 2 5 0 I P X U P G R A D E
Pit Cover Installation
Version 1
Model 200iPX/250iPX Upgrade Installation Guide
1-25
6
Place the right pit cover on the iPX drum module uprights and align the right pit
cover with the middle pit cover.
7
Loosely install the right pit cover to the drum guard mounting bracket using four
1/4-20 x 5/8-inch pan-head torx screws.
8
Loosely install the right pit cover to the iPX drum module uprights using four
3/8-16 x 1/2-inch button-head flange bolts.
9
Center the drum guard mounting bracket over the drum. Verify the drum does
not contact the mounting bracket.
10 Tighten all screws.
Figure 1-20: Install the Right Pit Cover to the iPX Drum Module
right pit cover
Advertising
This manual is related to the following products: