Dyno installation, Removing the dyno from the crate, Removing the dyno from the crate -7 – Dynojet 224/4WD: Installation Guide User Manual
Page 27
I N S T A L L A T I O N
Dyno Installation
Version 3
In Ground Model 224 4WD Automotive Dynamometer Installation Guide
2-7
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DYNO INSTALLATION
With the track assembly installed and secured to the pit floor, you are ready to install
the 224 4WD dyno.
R
EMOVING
THE
D
YNO
FROM
THE
C
RATE
You will need to provide equipment capable of lifting a minimum of 1588 kg
(3500 pounds) to lift the dyno off the crate and into position in your dyno room. You
will also need a pair of straps capable of supporting 1588 kg (3500 pounds) to attach
to the dyno. Dynojet recommends using a single loop style strap.
1
Route the single loop straps around the knurled part of the drum as shown.
Figure 2-5: Loop Strap Placement
loop strap
drum