Dynojet 424 Linx: DWRT Installation Guide User Manual
Page 17
4 2 4 L I N X I N S T A L L A T I O N
Flange Bearing, Outer Shaft, and Splined Shaft Installation
Version 6
Linx Installation for Model 424 Automotive Dynamometers
13
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
FLANGE BEARING, OUTER SHAFT, AND SPLINED SHAFT INSTALLATION
Use the following instructions to install the flange bearing, splined shaft, and outer
shaft on both the moveable and stationary dynos.
You will need the following parts:
• 32300001
Flange Bearing with Lock Collar (2)
• 36500016
Screw, 1/4-20 x 1.75", SHCS, Drilled (4)
• 36711100
Nut, 9/16-12, Hex (8)
• 36943101
Washer, 9/16", Flat (8)
• 61300030
Drive Pulley Shaft (Outer Shaft) (2)
• 62200006
Splined Shaft (2)
1
Place the flange bearing on the threaded studs on the inner plate.
2
Loosely secure the flange bearing to the inner plate using four 9/16-inch washers
and four 9/16-inch nuts.
3
Slide the outer shaft into the bearing.
Figure 9: Install the Flange Bearing and Outer Shaft
XD049
flange bearing
outer shaft