Dynojet 424x: Installation Guide - Manual (Page 161)

S T A T I O N A R Y D Y N O U P G R A D E
Deck Relocation
Version 8 Above Ground Model 424x/424xLC 2 Automotive Dynamometer Installation Guide
C-9
8 Remove the two 3/8-16 x 1-inch bolts, washers, and nuts securing each outer deck
brace to the mounting bracket and set aside.
9 Remove the outer deck braces and set aside.
Note: If you have and eddy current brake, the outer deck brace will secure right
to the brake with no mounting bracket.
10 Remove the two 3/8-16 x 1-inch bolts securing each inner deck brace to the dyno.
11 Remove the inner deck braces and set aside.
Figure C-8: Remove the Deck Braces
AD097
mounting bracket
outer brace
inner brace
outer brace
mounting bracket