Dynojet Scooter Dyno SD-12 Installation Guide - Manual (Page 26)

Model SD12 Scooter Dynamometer Installation Guide
C H A P T E R 2
Fold and Move the Dyno
2-10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
FOLD AND MOVE THE DYNO
Use the following instructions to fold and move the scooter dyno.
F OLDING THE D YNO
1 Lift the front support up until it clicks and locks into place.
2 Lift the spring plunger and slide the wheel clamp forward on the front support.
Release the spring plunger to lock the wheel clamp in position.
3 Raise the ramp until it comes in contact with the front support.
4 Lift the spring plunger and slide the wheel clamp until it locks the ramp in place.
Release the spring plunger.
Figure 2-9: Folding the Dyno
SD021
slide wheel clamp to
lock ramp in place
slide wheel
clamp forward
lock front support
in place
raise ramp