Dynojet Snowmobile Dynos: Installation Guide - Manual (Page 22)

Application #1
- Polaris
- Yamaha
- Ski Doo / Bombardier
- Arctic Cat
Rear Carriage Mount should oriented so that 4
out of the 6 holes are towards the front of the
carriage. (The triangular braces are facing
towards the Front Carriage Mount)
Application #2
- Fast M-10
- AD Boivin
- Similar Designs to the above where additional
Front Carriage Mount clearance is needed.
Rear Carriage Mount should oriented so that 4
out of the 6 holes are towards the rear of the
carriage. (The triangular braces are facing
towards the Dynojet Driver Assembly (not
shown))
Step 3
Install the Driver Set in the Carriage Frame. The
process is the same as installing it in the sled’s
suspension rails. Refer to the video on installing
Driver Sets that was supplied with your dyno.
The spacing between the Driver Carriage rails is
8.5”, similar to setting up a Driver Set for a Ski-
Doo snowmobile.
3-4 Document # 98260100
Note: The spacing on the Driver Set for the
Driver Carriage stays consistent, even
when testing snowmobiles from different
manufacturers.