Eden N8 (2006) - Manual (Page 5)

5
BACK PANEL FEATURES
Amplifier Power Rating:
RMS output:
40 Watts @ 4 Ohms
Fuse Holder – to replace the fuse, use a small screwdriver or coin to rotate
the fuse holder. Remove the holder and replace the fuse with the correct
value fuse. USE ONLY THE SAME SIZE AND TYPE FOR
REPLACMENT. Using a fuse with a different rating than specified is a
VERY BAD THING and can cause damage to your amplifier. All
models are set up to operate properly in the country of sale. It is NOT
possible to reconfigure your unit to operate in other countries.
Fuse Requirements:
USA @ 120 Volts /60 HZ – 2 Amps, 5 x 20 mm GMC/T/slow blow
Europe @ 240 Volts/50 Hz – 1 Amps, 5 x 20 mm GMC/T/slow blow
IMPORTANT NOTE: Always use slow blow or time delay type fuses.
Do not use fast blow fuses.
Power Cord – OK, this should be obvious. Plug this cord into a wall outlet.
Never, and we mean NEVER, use a ground lift or remove the third prong of
the plug. Disconnecting the ground from your unit can significantly increase
your risk of injury. Removing the third prong from your plug will also
immediately void your warranty. You have now been warned.
Cooling System – Your amplifier features a passive cooling system, which
operates automatically.
IMPORTANT NOTE: Excessive heat is a Very Bad Thing and can
result in severe damage to your amplifier. DO NOT cover the
ventilation holes on the back of your amp, as this will cause your
amplifier to overheat. Doing so will immediately void your warranty!