Crimestopper Security Products RS800 - Manual (Page 3)

OPERATION
ANTI-GRIND / STARTER DISABLE (OPTIONAL)
Prevents the driver from accidentally grinding the starter if the Ignition key is turned too far (to the start position) while
engine is already running from the remote starter. Starter circuit is automatically disabled when doors are locked using
the remote control to act as an added security feature.
VALET MODE / STARTER DISABLE OVERRIDE
Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into valet mode. The
remote start function WILL NOT operate when in Valet mode. To enter Valet mode, turn the key to the ON position,
press and hold Program/Valet switch for 6 seconds. The LED will turn on solid and the system is now in valet. Perform
this procedure again to exit of Valet mode. The keyless entry will still function normally while in valet mode. In the event
of a lost or broken transmitter, perform this step to override the Optional Starter Disable (If installed).
HOOD OPEN SAFETY SWITCH (WITH INSTALLED HOOD PIN SWITCH)
Prevents the engine being Remote Started when hood is open and will abort a remote start if running. Eliminates risk of
injury to someone working under the hood of the vehicle. This unit will not attempt a start if a hood pin is installed.
BRAKE PEDAL RESET CIRCUITRY
Prevents starting or shuts off a remote started vehicle when this circuit is active or activated. Prevents unauthorized
tampering. This circuit shuts the system down immediately when brake pedal is pressed if key is not in ignition and
turned to the run position.
NOTE:
In the event of a major malfunction, performing electrical service or jumpstarting the vehicle you should remove the main
Power Fuse(s) to protect the unit from possible damage.
TRANSMITTER PROGRAMMING
Note: All transmitter codes must be learned at time of programming!! The RS800 allows storage of up to 4
different transmitter codes.
1. Open Hood (Ground Gray hood pin wire if no hood pin is installed).
2. Turn key to the ON position.
3. Press Programming button 4 times. After a few seconds, the unit will flash the parking lights 4 times.
4. Press button #1 of the transmitter to be coded. You should get 2 light flashes indicating the unit is waiting for a 2
nd
code, then press button #1 of a second transmitter, the unit will flash 3 times indicating its waiting for the 3 rd code and
4 flashes for the 4 th code. If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise
turn key off and close hood.