Elecraft KXB3080 User Manual
Page 10
10
Bend C4 toward L8, if needed,
to clear the KXB3080 PCB.
Pass wire
from pad F
through
the hole in
this circuit
via to the
other side
of the PCB.
It will be
connected
later.
NOTE:
PCB
are incorrect. Connect the KXB3080 as shown here.
The markings on the bottom of the KX1
for pads A and B
Figure 7. Installed KXB3080 PCB.
Make sure the bare G, C and G leads are passing through the correct solder pads and the KXB3080
module is in position, then solder all three leads and trim the excess flush with the PCB.
Route the white Kynar® wire from KXB3080 pad F around potentiometer R2 and through the hole in
the circuit via next to T2 as shown in Figure 7. Pull all the excess wire through to the other side of the PCB.
It will be connected later.
Solder the remaining leads to their respective pads as shown in Figure 6.
__ D
__ 5
__ E
__ B
__A