Elecraft K2 Owner's Manual - Manual (Page 32)

E
LECRAFT ® 31
Remove the brown paper backing from the other side of each
piece of tape, then turn the filter/tape assembly adhesive-side down.
Carefully center the green plastic filter over the inside of the bargraph
LED hole (Figure 5-14).
Tape
Green Film
Figure 5-14
Turn the front panel face up.
Position the clear plastic LCD bezel over the LCD and bargraph
holes as shown in Figure 5-15. The bezel goes on the outside of the
panel.
Secure the bezel with four 2-56 screws (stainless steel) as shown
in Figure 5-15. Tighten the 2-56 screws only the amount needed to
hold the bezel to the front panel. Over-tightening may crack the
bezel or strip the threaded holes in the panel.
E L E C R A F T K 2 T R A N S C E I V E R
2-56 Screw (4) LCD Bezel
Figure 5-15