Elecraft K3-Remote Owner's Manual - Manual (Page 15)

15
2. Locate the port forwarding page. On the Linksys router, this is under Applications and Gaming. With
other routers, likely it will be under a similar heading. Enter the following data as shown in Figure 11.
Be sure to check Enable for each entry, and then click on Save Settings to save the changes.
Application Start End Protocol IP Address
RRIG_cmd 13002 13002 Both (UDP and TCP) 192.168.1.170
RRIG_audio 13001 13001 Both (UDP and TCP) 192.168.1.170
RRIG_sip 13000 13000 Both (UDP and TCP) 192.168.1.170
*Note, if you have a VoIP Phone system, these default ports may conflict and need to be changed.
Figure 11
3. Save your changes. *Note, the router may need to be rebooted for settings to take effect.