Elecraft KAT500 Owners Manual - Manual (Page 30)

27
Locate the outline marked LB1 on the pc board. It is on the connector edge of the board next to the
power connector (see Figure 10).
Figure 10. Angle Bracket LB1 Mounting Location
Mount the angle bracket at LB1 on the pc board as shown in Figure 11. Note that it has a long and
short side. Be sure the long side is against the pc board as shown.
Figure 11. Installing the Angle Bracket.
Locate the bottom cover. It is the same size as the top cover, but you can identify it by the hole
pattern. Check the inside surface and remove any tape or other residue to ensure clean, bare metal at the
locations shown in Figure 12. This is important for proper grounding of the enclosure panels.