Elecraft P3SVGA - Manual (Page 11)

11
Replace the rear panel assembly on the P3 as shown in Figure 9. Tilt the assembly so the P3SVGA
board does not strike the screw head for the rear foot. The screw head fits in a notch on the P3SVGA
board. Secure the rear panel assembly with the screws you removed earlier (Figure 2
).
Figure 9. Replacing the Rear Panel on the P3.
Reconnect the TMP cable to the rear panel RF board (Figure 2 ).
Replace the top cover on the P3 with the notch to the rear using the screws you removed earlier:
REPLACE ALL THE SCREWS!
The P3's chassis strength depends upon all the screws being in place. Be sure to
replace all the screws and verify they are tight, but do not over-torque the screws.
That completes the installation of the P3SVGA option in your P3. Operating
instructions are on pg 5.