Clarion DXZ665MP - Manual (Page 23)

280-8331-00
DXZ665MP
23
English
Operations Common to Each Mode
● Setting the method for title scroll
Set how to scroll in CD-TEXT, MP3/WMA title.
∗ The factory default setting is “ON”.
2-1. Select “ AUTO SCRL”.
3-1. Turn the [ROTARY] knob to select “ON” or
“OFF”.
• ON:
To scroll automatically.
• OFF:
To scroll just 1 time when the title was
changed or the [T] button was pressed for 1
second or longer.
● Dimmer control
You can set the dimmer control “ON” or “OFF”.
∗ The factory default setting is “ON”.
2-1. Select “ DIMMER”.
3-1. Turn the [ROTARY] knob to select “ON” or
“OFF”.
To change other settings
1. Press the [ADJ] button to switch to the
adjustment selection display.
2. Press the [ å , ∂ ] lever upward or
downward to select the “item name”.
Each time the [ å , ∂ ] lever is pressed
up/down, the item display changes in the
following order:
“ BLINK LED” ↔ “ AMP CANCEL”
↔ “ SID DISP” ↔ “ AUX SENS” ↔
“ SYSTEM”
3. Turn the [ROTARY] knob to select the
“desired setting item”.
∗ After completing settings, press the [ADJ]
button to return to the previous mode.
● Anti-theft indicator
The red Anti-theft indicator is a function for
preventing theft. When the DCP is removed
from the unit, this indicator blinks.
∗ The factory default setting is “OFF”.
2-1. Select “ BLINK LED”.
3-1. Turn the [ROTARY] knob to select “ON” or
“OFF”.
● Setting the external amplifier
∗ The factory default setting is “OFF”.
2-1. Select “ AMP CANCEL”.
3-1. Turn the [ROTARY] knob to select “ON” or
“OFF”.
• ON:
Use with connected AMP.
• OFF:
Use with inside AMP.
● Displaying the Satellite ID No.
∗ This function only applies when a Satellite receiver
is connected.
∗ The factory default setting is the upper 6 digits.
2-1. Select “ SID DISP”.
3-1. Turn the [ROTARY] knob to switch between
the display for the upper 6 digits and lower
6 digits.
● Selecting AUX IN sensitivity
Make the following settings to select the
sensitivity when sounds from external devices
connected to this unit are difficult to hear even
after adjusting the volume.
∗ The factory default setting is “MID”.
2-1. Select “ AUX SENS”.
3-1. Turn the [ROTARY] knob to select “LOW”,
“MID” or “HIGH”.
● Performing a system check
This function allows you to perform a system
check from the adjust mode when required.
2-1. Select “ SYSTEM ”.
3-1. Press and hold the [ ] button for 1
second or longer.
“SYSTEM CHECK” appears in the display,
then the unit returns to the previous
operation mode.