ETS-Lindgren 2187 Turntable - Manual (Page 23)

Assembly and Installation | 23
IR Repeater Installation
I NSTALLATION A SSEMBLY C OMPONENTS
• Infrared
sensor
• Mounting
collar
•
IR-100 control unit
•
IR flasher LED
• 9–12VDC
power supply
• Connection
cable
•
Flathead mounting screws
R EQUIRED T OOLS FOR I NSTALLATION
• Electric
drill
•
1-in hole saw to create a
•
1/16-in drill bit
•
Small flat blade screwdriver
•
Phillips #2 bit driver
• Adhesive
tape
I NSTALLATION S TEPS
1. Choose a location for the IR infrared sensor that is away from traffic.
2. Using a 1-in hole saw, cut an opening in the floor for the IR sensor.
3. Connect the V+, GND, and SIG wires to the IR sensor as shown in the
diagram, and feed the cable through the hole.