Fast Forward Video Omega HD - Manual (Page 6)

6 Omega HD Manual, Fast Forward Video
We recommend that you have the drives installed, formatted and tested by Fast Forward Video. However, you may install
2.5” Drive Removal/Replacement Procedure:
1. Open the front panel door by rotating the ¼ turn knob counter-clockwise on the lower left corner of the door.
2. Each tray has a black push button drive release located on the right of the drive bay.
3. To install a drive remove the two screws from the rear panel of the drive enclosure.
4. Remove the circuit board from the drive enclosure.
5. Attach the 2.5” SATA hard drive to the circuit board, and fasten it to the board using drive mounting screws.
6. Once the hard drive has been secured on the circuit board, replace the circuit board (with hard drive attached) in the
drive enclosure (drive facing up). Fasten the rear panel of the drive enclosure, using the screws that were removed in
step #3.
7. Slide the drive back into the enclosure bay.
Drive Installation