Fast Forward Video NDT 200 - Manual (Page 6)

NDT 200™ 6 l a u n a M
Front Bezel Buttons and Functions
POWER Switch: The green pushbutton is the power button, press and release to start the NDT 200G.
When the unit is “On”, pressing the power button for 5 seconds will turn the unit “Off”.
PASS-THRU: The LED below the power switch will flash red once per second indicating that it is in
digital pass-thru mode, which indicates the D.V.R. is record ready. The status line of the LCD panel will
also display PASS-THRU at this time.
Pushbutton Operation
Function Req. State Keys Notes
Start Record Any but Record REC
Stop Record Record ■ + REC Hold Stop and tap Record
Change to Pass-Thru Play or Stop ■ + REC Hold Stop and tap Record
Play forward – 1x Stop ►
y a l P e s u a P ■
Step Fwd 1 frame Play or Stop ■ + Hold Stop and tap Fast Fwd
Step Rev 1 frame Play or Stop ■
+
Hold Stop and tap Rewind
Seek to end of loaded
clip
Play or Stop
Seek to start of loaded
clip
Play or Stop
Scan Fwd – 5x Play ≠ 5x ► + Hold Play and tap Fast Fwd
Scan Fwd – 30x Play = 5x ► + Hold Play and tap Fast Fwd
Scan Rev – 5x Play ≠ -5x ► + Hold Play and tap Rewind
Scan Rev – 30x Play = -5x ► + Hold Play and tap Rewind
Clear Disk Any but Record
+ + REC
Push and hold , then , then press REC
and release all three (LED flashes red and
green quickly), then press and hold REC for 5
seconds. LED will flash fast red, until last two
seconds of format - it changes to fast green
blink. Returns to slow red blink when ready to
record.