For your safety, Specifications, Set up and basic operation – Fiilex P180 User Manual

Page 2: Optional accessories, D-tap cable, Dome diffuser rain guard, Fresnel lens

Advertising
background image

8

9

Information and Specifications in this document are subject to change without notice. DiCon
Lighting, Inc. assumes no responsibility or liability for any error or inaccuracies that may
appear in this manual. Unlawful reproduction or distribution in any manner without the
written permission of DiCon Lighting, is strictly prohibited.

© DiCon Lighting 1996-2013 All Rights Reserved

Fiilex.com
1689 Regatta Blvd. Richmond, CA 94804
(510)620-5155 . [email protected]

For Your Safety

•Do not attempt to disassemble the body of the P180.

•Do not install or operate the P180 in a damp or wet area

without the use of rain guard.

•Do not directly cover the side and/or back air vents.

Allow for proper air flow.

•Use only included power supply or optional D-Tap Cable.

Failure to do so may cause damage to the LED light.

•Use only a soft, dry towel to gently clean the exterior of

light when needed.

•Before powering up for the first time, please remove any

or all protective membranes from the light.

7

Specifications

Size (without Barndoor)

2.9” x 2.9” x 3.3” / 74.2 x 74.2 x 85mm

Weight (Includes Yoke)

1.2 lb/527g

LED

Dense Matrix LED

Thermal Design

Advanced Vapor Cooling System

CCT Range

Continuous from 3000 - 5600 K

CRI

>90

Power Consumption

40W Max / Comparable in output to 200W Tungsten

Power Input

12 to 24V DC

AC Adapter

100-240V AC, 50-60Hz (In) / 19V DC, 65W Max (Out)

Operating Temperature

- 30 to 40 °C

6

5

4

Set Up And Basic Operation

1

2

3

4

5

6

7

Mount Light Stand Adapter (G) to stud on light stand,
tripod, or Cold Shoe Mount(H).

Insert the DC Power Plug into DC Power Input Jack (L).

Press the On/Off Button (K) to power on the P180.

Adjust the correlated color temperature (CCT) with
the CCT Tuning Knob (J).

Adjust the intensity and dim the light with the
Intensity Knob (I).

Loosen the Yoke Knob (E) to install optional Rain
Guard or Umbrella Holder.

Slide the Barndoor (A) into the Barndoor Slot (B)
until it clicks into place.

1

2

5

4

6

7

3

D-tap Cable

See website for additional accessories. www.fiilex.com

Dome Diffuser

Rain Guard

Optional Accessories

Fresnel Lens

Advertising