English, Caution, Warning – Clarion MAX685BT User Manual

Page 73: Installation precautions

Advertising
background image

71

MAX685BT

English

INSTALLATION

MANUAL

Installation Precautions

CAUTION

CAUTION

• Do not install the system in the locations

described below. This may cause a fire,
accident or electrical shock:
A location exposed to rain or dust.
A location interfering with the driver’s
visual range or operation of the vehicle.
An unstable location, or where the system
may fall.

• Do not install this unit in a place exposed to

direct sunlight, heat or a place where the
vent holes or heat radiation holes are
covered.

• When you install the antenna, mount it in a

place where the elements of the antenna do
not protrude beyond the edge of the front,
back, left and right of the vehicle.

• If it comes in contact with pedestrians, it

may cause an accident.

Installation Notes

CAUTION

CAUTION

• Use only the supplied parts.
• If unspecified parts are used, they may

cause damage.

• Any holes made in the body of the vehicle

should be sealed with a silicon adhesive.

• If exhaust fumes or water penetrates into

the vehicle, this may cause an accident.

• Fasten the bolts securely when installing

the unit. If the bolts are loose an accident or
malfunction could occur.

Connection Notes

CAUTION

CAUTION

• Verify wires with a digital multi-meter prior

to making any connections. Many new
vehicles use multiplexed and/or low voltage
circuits that can be damaged if a test light
or logic probe is used.

• Connect cables appropriately. If a wrong

connection is made, this may cause a fire or
accident.

• When passing cables through the body of

the vehicle, use non-conductive grommets.

• If the coatings of the cables are worn out by

rubbing, this may cause an accident, fire or
a short circuit.

• After wiring cables, fix them with insulation

tape.

• Be sure to switch off the vehicle when

connecting or disconnecting cords to/from
the unit, otherwise an electric shock, injury
or accident may occur.

WARNING

• When installing the unit to a vehicle with

an airbag system, never install it in a
place where it may affect the operation of
the airbag.

• Do not install this unit in the following

locations:
A location interfering with the driver’s
visual range or operation.
A location where the gear shift or brake
pedal are hindered.
A location where passengers are at risk.
An unstable location, or where the
system may fall.

WARNING

• Please note the position of pipes, tanks

and electrical wirings before installing
the unit into the vehicle; failure in
avoiding these may cause a fire or
malfunction.

WARNING

• Loom all cables according to the

instruction manual, so as not to hinder
operation.

• Wire the connecting cords/cables away

from high temperature areas. If the
coatings of the cables melt, it could
cause an accident/fire by a short circuit.
Take care when wiring in the engine
compartment.

• When wiring the connecting cables in a

vehicle with an airbag system, never feed
the cables through a place where it may
affect the operation of the airbag.

• An airbag not operating correctly in an

emergency may cause increased injury.

Advertising