Hollywood Racks HR8100 Traveler 2 arm - Manual

Traveler Hitch Rack
Assembly and Use Instructions for Traveler Series Racks
HR6000 3- Bike Rack for 2” receiver HR6100 3 Bike Rack for 1-1/4” receiver
HR8000 4 Bike Rack for 2” receiver HR8100 4 Bike Rack for 1-1/4” receiver
HR9200 5 Bike Rack for 2” receiver
Warning!
This product
NOT
to be used on any trailer or trailered vehicle.
 Drive slowly when using the rack on bumpy or dirt roads.
 Check the rack bikes and straps regularly during use.
 If you have any questions or installation problems, please see your Hollywood Racks retailer or
contact Hollywood Engineering at 800-747-4085.
3. Hitch Insert Tube (Fig. 3 ) and Upright beam assembly
4. Two Support arms with bike cradles and anti-sway blocks attached (Fig. 5 and 6).
5. One long attachment/safety strap
(86” long) – Not shown.
After opening the Traveler box, you
should have the following parts:
1. Parts bag including two male knobs
and two spacer blocks. (Fig. 1)
.2. Parts bag including: threaded hitch
pin, hitch pin clip, star and flat washers,
¾” head through bolt, large washers and
self-fastening (nyloc) nut. (Fig. 2)