Clarion CMD5 - Manual (Page 22)

Common Operations
22
CMD5
English
Adjusting the non-fade volume
* The factory default setting is “NFVOL +6”.
(Adjustment range: –6 to +6)
1. Press the [MENU] button to switch to the
menu mode.
2. Press the [
E] or [e] button to select “NF VOL”.
3. Turn the [VOLUME] knob to adjust the
nonfader volume.
4. Press the [MENU] button to return to the
previous mode.
Verifying your SIRIUS ID (Sirius
mode only)
1. Press the [MENU] button to switch to the
menu mode.
2. Press the [
E] or [e] button to select “SID
DISP”.
3. Press the [ENT] button.
The source unit displays the high-order 6
digits of the SIRIUS ID in the Operation status
information.
4. Turn the [VOLUME] knob clockwise to change
the low-order 6 digits of the SIRIUS ID.
To display the high-order 6 digits of the
SIRIUS ID again, turn the [VOLUME] knob
counterclockwise.
5. Press the [ENT] button.
6. Press the [MENU] button to return to the
previous mode.
Switching TV/VTR mode (TV mode
only)
This function switches TV to VTR.
1. Press the [MENU] button to switch to the
menu mode.
2. Press the [
E] or [e] button to select “TV/VTR”.
3. Press and hold the [ENT] button to select TV
or VTR.
Setting the TV area (TV mode only)
The TV tuner area setting changes by the TV
area you selected.
1. Press the [MENU] button to switch to the
menu mode.
2. Press the [
E] or [e] button to select “TV AREA”.
3. Turn the [VOLUME] knob to select the
reception area.
4. Press the [MENU] button to return to the
previous mode.
The above operations are required when a TV
tuner other than TTX7501z is connected.
Setting the TV diver (TV mode only)
You can change the reception setting for the TV
antenna connected to the TV tuner.
1. Press the [MENU] button to switch to the
menu mode.
2. Press the [
E] or [e] button to select “TV
DIVER”.
3. Turn the [VOLUME] knob to set the setting to
“ON” or “OFF”.
●ON:
Sets reception emphasizing the visual.
●OFF:
Sets the diver setting to OFF.
4. Press the [MENU] button to return to the
previous mode.
Selecting AUX IN sensitivity (AUX
mode only)
Make the following settings to select the
sensitivity when sounds from external devices
connected to this unit are difficult to hear even
after adjusting the volume.
* The factory default setting is “MID”.
1. Press the [MENU] button to switch to the
menu mode.
2. Press the [
E] or [e] button to select “AUX
SENS”.
3. Turn the [VOLUME] knob to select from
“HIGH”, “MID” or “LOW”.
4. Press the [MENU] button to return to the
previous mode.
Note:
• For telephone interrupt, AUX SENS is always
“MID”.
Adjusting the display contrast
You can adjust the display contrast to match the
angle of installation of the unit.
* The factory default setting is “4”. (Adjustment
level: 1 to 8)
1. Press the [MENU] button to switch to the
menu mode.
2. Press the [
E] or [e] button to select
“CONTRAST”.
3. Turn the [VOLUME] knob to adjust the
contrast.
4. Press the [MENU] button to return to the
previous mode.