Home Legend Cork - Manual (Page 5)

Doc. ID: 136 Rev: 3 Effective: 1/25/2014 Page | 5
Floating Installation Procedure
Step 1 - Pre-install Activities
• Rack up planks from several boxes.
• Ensure that end joints are staggered at least 6” between the rows. See diagram below.
• Inspect product for defects. If material is questionable, contact the retailer immediately. Do not proceed with installation
Step 2 – Install Moisture Barrier (if on concrete) and Optional Underlayment if selected.
• For concrete, let the moisture barrier run up the wall a bit before cutting to size.
• Install the underlayment on top of the moisture barrier. Cut 1 inch from the wall. See diagrams below.
Step3 – Install the First Row
• Saw off the tongue from the length and width of the first plank. Create expansion gap by placing spacers be-tween the planks and
the walls for expansion.
• Saw off the tongues from only the length of the remaining planks to be installedin the first row..
• Use the angling method to connect and lock the joints between the planks. Remember to use the spacer for maintaining expansion
gap. See diagrams below.
Step 4 – Install the Remaining Rows
• Stagger the end joints by at least 6 inches. Use angling method to lock the joint along the long edge.
• Use the angling technique to lock the long edge together.
• Use either the tapping block or pull bar to drive the next plank toward the first plank until the end joints are locked.
• Repeat the steps until the row is complete. See diagrams below.