Installation, Step 1, Step 2 – Chamberlain RIFMS2 User Manual

Page 3: Step 3, Step 4

Advertising
background image

3

Step 4

Place intercom in frame by inserting top section first,
then snapping the lower section into place.

Step 3

Place the frame in the hole
and tighten screws.
NOTE: Place frame in wall so
that the two small slots are on
the top and the larger single
slot is on the bottom.

Step 2

Insert a screw into each
hole in the frame and attach
the fasteners. Tighten screw
only 1/4" into the fastener.

Step 1

Cut a hole in the wall measuring 6 1/8" wide by
4 1/2" high.

6 1/8"

4 1/2"

Choose mounting locations where both intercoms will
work when tested.
NOTES:
• The wall location should be clear of beams and

other obstructions inside the wall.

• Do not mount intercoms within 6' of each other.
• Do not mount intercom near any electrical wiring or

electrical devices.

Installation

Advertising