Off-road driving tips, When to use 4wd low range, If equipped – Jeep 2007 Commander User Manual

Page 270: Driving through water

Advertising
background image

OFF-ROAD DRIVING TIPS

NOTE:

Prior to off-road driving, remove the front air

dam to prevent damage. The front air dam is attached to
the lower front fascia with quarter turn fasteners, and can
be removed by hand.

When To Use 4WD LOW Range — If Equipped

When off-road driving, shift to 4WD LOW for additional
traction. This range should be limited to extreme situa-
tions such as deep snow, mud, or sand where additional
low speed pulling power is needed. Vehicle speeds in
excess of 25 mph (40 km/h) should be avoided when in
4WD LOW range.

Driving Through Water

Although your vehicle is capable of driving through
water, there are a number of precautions that must be
considered before entering the water:

CAUTION!

When driving through water, do not exceed 5 mph (8
km/h). Always check water depth before entering as
a precaution, and check all fluids afterward. Driving
through water may cause damage that may not be
covered by the new vehicle limited warranty.

Driving through water more than a few inches deep will
require extra caution to ensure safety and prevent dam-
age to your vehicle. If you must drive through water, try
to determine the depth and the bottom condition (and
location of any obstacles) prior to entering. Proceed with
caution and maintain a steady controlled speed less than
5 mph (8 km/h) in deep water to minimize wave effects.

Flowing Water
If the water is swift flowing and rising (as in storm
run-off) avoid crossing until the water level recedes

270

STARTING AND OPERATING

Advertising