Esp/bas warning light and esp/tcs indicator light – Jeep 2009 Commander User Manual

Page 338

Advertising
background image

WARNING!

HDC is only intended to assist the driver in control-
ling vehicle speed when descending hills. The driver
must remain attentive to the driving conditions and
is responsible for maintaining a safe vehicle speed.

ESP/BAS Warning Light And ESP/TCS Indicator
Light

The malfunction indicator lamp for the ESP is
combined with the BAS indicator. The ESP/
BAS Warning Light and the ESP/TCS Indicator
Light in the instrument cluster both come on

when the ignition switch is turned to the ON position.
They should both go out with the engine running.

If the ESP/BAS Warning Light comes on con-
tinuously with the engine running, a malfunc-
tion has been detected in either the ESP or the
BAS system, or both. If this light remains on

after several ignition cycles, and the vehicle has been
driven several miles at speeds greater than 30 mph
(48 km/h), see your authorized dealer as soon as possible
to have the problem diagnosed and corrected.

NOTE:

• ЉThe ESP/TCS Indicator Light and the ESP/BAS

Warning Light come on momentarily each time the
ignition switch is turned ON.

• Each time the ignition is turned ON, the ESP System

will be ON even if it was previously turned off.

• The ESP Control System will make buzzing or clicking

sounds when it is active. This is normal; the sounds
will stop when ESP becomes inactive following the
maneuver that caused the ESP activation.

336

STARTING AND OPERATING

Advertising