Rear drive assembly (rda) - awd/4wd models only, Rear drive assembly (rda) – awd/4wd, Models only – Jeep 2009 Compass - Owner Manual User Manual

Page 369

Advertising
background image

Fluid Level Check
Check the fluid level by removing the fill plug. The fluid
level should be between the bottom of the fill hole and a
point not more that 3/16 in (4.7 mm) below the bottom of
the hole.

Add fluid, if necessary, to maintain the proper level.

Frequency Of Fluid Change
Under normal operating conditions, the fluid installed at
the factory will give satisfactory lubrication for the life of
the vehicle. Fluid changes are not necessary unless lubri-
cant has become contaminated with water.

NOTE:

If contaminated with water, the fluid should be

changed immediately.

Rear Drive Assembly (RDA) – AWD/4WD Models
Only

Lubricant Selection
Use only the manufacturer’s recommended fluid. Refer
to “Fluids, Lubricants, and Genuine Parts” in this section
for the correct fluid type.

Fluid Level Check
Visually inspect the unit at each oil change for leakage. If
leakage is detected, check the fluid level by removing the
fill plug. The fluid level should be maintained between
the bottom of the fill hole to 1/8 in (4 mm) below the fill
hole.

Add fluid, if necessary, to maintain the proper level.

Frequency Of Fluid Change
Refer to the “Maintenance Schedule” in Section 8 for the
correct maintenance interval.

MAINTAINING YOUR VEHICLE

367

7

Advertising
This manual is related to the following products: