Jeep 2009 Liberty - Quick Reference Guide - Manual (Page 5)

fuel cap:
Loose gas caP message
• If a “gas cap” message (shown as gASCAP or CHECK GASCAP) appears,
tighten the gas cap until a “clicking” sound is heard.
• Press the odometer reset button to turn the message off.
• If the message continues to appear for more than three days after
tightening the gas cap, see your dealer.
Tire preSSure moniToring
SySTem (TpmS):
• If one or more of the four road tire pressures are low, the Tire Pressure
Monitoring Light will illuminate and an audible chime will sound.
• Check the inflation pressure of each road tire on your vehicle and inflate
to the recommended cold pressure value, shown on the placard located
in the driver’s door opening. The TPMS light should not be used as a tire
pressure gauge when adjusting your tire pressure.
• The light will turn off once the updated tire pressure has been recognized.
The vehicle may need to be driven for up to 20 minutes above 15 mph
(25 km/h) before the light will turn off.
• Temperature changes can affect tire pressures, causing the TPMS light
to turn on. Colder temperatures will decrease tire pressure and warmer
temperatures will increase tire pressure.
• If your spare tire’s pressure is low or in use on the vehicle, the TPMS light
may turn on. Refer to your Owner’s Manual.
oil change indicaTor:
message
• If an “oil change” message (shown as CHAngE Oil or Oil Change
Required) appears and a single chime sounds, it is time for your next
required oil change.
resetting Light after servicing
• Turn the ignition switch to the ON/RUN position (do not start engine).
• Fully depress the accelerator pedal three times within 10 seconds.
• Turn the ignition switch to the OFF/LOCK position.
rotate blower control rotate Temp. control rotate mode control
push air recirc.
button
push a/c
button
push rear window
defroster button
manual climaTe conTrolS:
air recircULation
• Use recirculation for maximum A/C operation.
• For window defogging, turn recirculation off.
• Recirculation is not allowed in defrost, floor, defrost/floor (mix) modes.
driver power SeaT:
• This switch, located on the outboard side of the seat, controls the forward/
backward and up/down movement of the seat.
driver memory SeaT:
• The memory seat feature allows you to save two different driver seating
positions. With the key in the ON/RUN position, push , then 1 or 2
within five seconds.
• Push 1 or 2 to recall the saved positions.
• Key fobs may be programmed to automatically recall position 1 or 2 when
UNLOCK is pushed.
• Refer to Owner’s Manual for programming instructions.
S
vehicle features