Jeep 2009 Wrangler - Owner Manual - Manual (Page 194)

5. Install the lower windshield plates with the six black
round-headed Torx
௡ head screws (using a #40 Torx௡ head
driver) on each side of the base of the windshield.
6. Reinstall the wiper arms.
REAR WINDOW FEATURES — HARD TOP ONLY
Rear Window Wiper/Washer — If Equipped
A rotary ring switch on the control lever (located on the
right side of the steering column), controls the operation
of the rear wiper/washer function. Rotating the center of
the switch up to the “On” position will activate the wiper.
Rotating the switch ring beyond the “On” or “Off”
position will activate the rear washer. The washer pump
will continue to operate as long as the lever or ring is
engaged. Upon release, the wipers will cycle three times
before returning to the set position.
192 UNDERSTANDING THE FEATURES OF YOUR VEHICLE