Forward collision warning (fcw) with mitigation, Forward collision warning (fcw), With mitigation – Jeep 2015 Grand Cherokee SRT - User Guide User Manual

Page 49: Operating your vehicle

Advertising
background image

FORWARD COLLISION WARNING (FCW) WITH

MITIGATION

The Forward Collision Warning (FCW) system with mitigation provides the driver with
audible warnings, visual warnings within the DID, and may apply a brake jerk to warn
the driver when it detects a potential frontal collision. The warnings and limited
braking are intended to provide the driver with enough time to react, avoid or mitigate
the potential collision.

NOTE:
FCW monitors the information from the forward looking sensors as well as the
Electronic Brake Controller (EBC), to calculate the probability of a forward collision.
When the system determines that a forward collision is probable, the driver will be
provided with audible and visual warnings and may provide a brake jerk warning. If
the driver does not take action based upon these progressive warnings, then the
system will provide a limited level of active braking to help slow the vehicle and
mitigate the potential forward collision. If the driver reacts to the warnings by braking
and the system determines that the driver intends to avoid the collision by braking
but has not applied sufficient brake force, the system will compensate and provide
additional brake force as required.

Turning FCW ON Or OFF

NOTE:
The default status of FCW is “On”, this allows the system to warn you of a possible
collision with the vehicle in front of you when you are farther away and it applies
limited braking. This gives you the most reaction time to avoid a possible collision.

The forward collision button is on the switch panel that is located in the center of the
instrument panel.
• To turn the FCW system OFF, press the forward collision button once (LED turns

on).

• To turn the FCW system back ON, press the forward collision button again (LED

turns off).

Changing FCW Status

The FCW feature has two settings and can be changed within the Uconnect

®

System

Screen:
• Far
• Near

NOTE:
The FCW and active braking settings can only be changed when the vehicle is in
PARK.

OPERATING YOUR VEHICLE

47

Advertising
This manual is related to the following products: