Fluid level check, Frequency of fluid change, Rear drive assembly (rda) — awd/4wd models only – Jeep 2015 Patriot - Owner Manual User Manual

Page 508: Lubricant selection, Rear drive assembly (rda) — awd/4wd, Models only

Advertising
background image

Fluid Level Check
Check the fluid level by removing the fill plug. The fluid

level should be between the bottom of the fill hole and a

point not more than 3/16 inch (4.7 mm) below the bottom

of the hole.
Add fluid, if necessary, to maintain the proper level.
Frequency Of Fluid Change
Under normal operating conditions, the fluid installed at

the factory will give satisfactory lubrication for the life of

the vehicle. Fluid changes are not necessary unless lubri-

cant has become contaminated with water.
NOTE:

If contaminated with water, the fluid should be

changed immediately.

Rear Drive Assembly (RDA) — AWD/4WD Models
Only

Lubricant Selection
Use only the manufacturers recommended transmission

fluid. Refer to “Fluids, Lubricants, and Genuine Parts” in

“Maintaining Your Vehicle” for further information.
Fluid Level Check
Visually inspect the unit at each oil change for leakage. If

leakage is detected, check the fluid level by removing the

fill plug. The fluid level should be maintained between the

bottom of the fill hole to 1/8 in (4 mm) below the fill hole.
Add fluid, if necessary, to maintain the proper level.
Frequency Of Fluid Change
Refer to the “Maintenance Schedule” for the proper

maintenance intervals.

506 MAINTAINING YOUR VEHICLE

Advertising