Kendon Stand-Up Trailer - Manual (Page 8)

Tie Down Engineering Axle Limited Warranty Tie Down
Tie Down Engineering (the Company) extends to the original pur-
chaser only, a limited warranty on each Tie Down axle assembly
against defects in material or workmanship of a period of
one(1)year from the date of purchase. THE FOREGOING WAR-
RANTY IS EXCLUSIVE & IN LIEU OF ALL OTHER WARRANTIES
EXCEPT THAT OF TITLE, WHETHER WRITTEN, OR IMPLIED,
INFACTOR INLAW (INCLUDING ANY WARRANTY OF MER-
CHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.)
A warranty period of five(5)years Is extended On ELIMINATOR
Torsion Axle suspension, exclusive of hubs, drums, brakes, bear-
ings and seals which are covered for a period of 1 year from the
date of purchase.
1.To obtain warranty service, please send the following information
to the address listed below.
A.Name and mailing address of purchaser.
B.Proof of date of purchase
C.Number of miles.
D.Name of manufacturer of unit under which axle is mounted.
E.Model, year and serial number of unit.
F.Name and address of dealer from whom unit was purchased.
G.Serial number of axle.
H.Description of the defect.
2.This warranty does not extend to:
A.The connecting of brake wiring to the trailer wiring or trailer wiring
to the towing vehicle wiring.
B.The attachment of the running gear to the frame.
C.Hub imbalance, or any damage caused thereby.
D.Parts not supplied by the Company.
E. Any damage whatever if caused by or related to any alteration
of the axle.
F.Use of axle assembly on unit other than that to which it was orig-
inally mounted.
G.Normal wear.
H.Alignment.
3. This warranty does not cover defects caused by:
A. Improper installation
B. Damage (not resulting from defect or malfunction) while in the
11
LOADING YOUR TRAILER
1. After your trailer has been properly attached to the tow vehicle
as previously described, you must fold out the back half of the trail-
er to load motorcycle(s). Make sure the area you are working in is
level, and both the surface area and trailer are dry to avoid slipping.
2. If your trailer is equipped with a loading ramp, you will find it
secured to the underside of the rear section. On the ATV/Utility
Trailer you'll find two ramps secured next to the front guardrails.
Make sure the ramp is properly secured to the trailer prior to load-
ing the motorcycle(s). Never attempt to ride your motorcycle(s) up
or down the loading ramp.
3. Because of the many designs and weight of motorcycles, it is the
owner's responsibility to determine if assistance is needed to load
or unload your particular equipment. However, we believe that in
the interest of safety, help should be acquired prior to any attempt
to load or unload motorcycles.
4. The Gross Vehicle Weight Rating of your trailer should never be
exceeded. Gross Vehicle Weight Rating (GVWR) is the total of the
trailer, and all equipment carried by the trailer. The maximum load
you may place on any Kendon trailer is 1000 pounds U.S. with the
exception of Dual-Rail Big Bike Transporter and ATV / Utility
Transport that have a load capacity of 2000 pounds U.S. If you
have any questions concerning your particular application please
call us at Kendon for advice.
5. Motorcycle(s) should be properly secured to the trailer with
Kendon locking ratchet tie -down straps. Motorcycle(s) being
transported must have at least four tie-down locations as to trian-
gulate the system to ensure stability during transportation. It is
MANDATORY that the following four locations be used:
6