Kendon STAND-UP MOTO LIFT - Manual (Page 5)

714‐630‐7144 www.KendonUSA.com
‐ 6 ‐
attachment points on your bike (i.e. Front frame rails, rear sub frame)
and attach the nylon straps to cam locks and secure the motorcycle
frame by making a choked loop with the nylon straps on all four
corners.
• Now your motorcycle is safely secured to the lift. You can safely
remove wheels/suspension with ease and safety without tipping the
motorcycle over.
WARNING: Detach the four (4) nylon straps from cam
locks before lowering the lift or the lift will not be able to
properly descend.
Descending/Unloading Your Motorcycle
WARNING: Suspension and wheel units must be
completely installed before descending to ground level.
• Detach the four (4) nylon straps from cam locks and the
motorcycle frame. Failure to detach these tie downs may result in tip
over or lockup on descent.
• Raise the lift manually or with air so that the bottom scissor safety bar
can be released.
• Release the bottom scissor safety bar.
• VERY SLOWLY turn the valve control knob counterclockwise to slowly
descend the lift until the bike tires firmly touch the bottom scissor
assembly.
• When the tires firmly touch the bottom scissor assembly, reattach the
front tie downs.
NOTE: It is advisable to hold the bike to stabilize the vehicle while
the lift is descending.
• Continue the final descent.
• When the lift is fully descended, detach the front tie downs.
• Roll the bike directly backwards off the lift.
• Have a great ride!
714‐630‐7144 www.KendonUSA.com
‐ 3 ‐
Moto Lift Expanded Drawing