KMC Controls TTE-1001 - Manual

TTE-1001 1 Installation Guide
Installation Guide
Room Temperature Transmitter
TTE-1001
Mounting
Standard:
• The base unit’s mounting slots are designed to
align with the holes in a standard 2" x 4" (51 x 102
mm) handy conduit box. Use such a box if using
conduit.
• On solid walls, normal screw and anchor systems
may be used.
Mounting 1
Connections and Wiring 2
Maintenance
2
Accessories 2
Important Notices 2
All dimensions are in inches (mm).
Hollow wall:
1. Cut a 3-3/4" x 1-3/4" rectangular opening in the
wall. (Check if unit is horizontal or vertical before
cutting.)
2. Make all necessary connections.
3. Insert an HMO-5001 Toggle Bolt Assembly
(ordered separately) through the wall and tighten.
NOTE: Care should be taken not to bend or flex the
base of the thermostat.