Koala Kare KB200-SS - Manual (Page 5)

Step 3. Mount Bed and Chassis
Screw two of the mounting screws into the
pilot holes leaving ¼” (6.35 mm) exposed
to allow keyhole slots to be easily mounted
over the screw heads. Place chassis
over screws as shown in illustration. After
securing the unit using the keyhole slots,
verify that the unit is level. Tighten top two
screws so that they are fl ush with the wall.
Use the four lower holes as a guide to
mark and drill pilot holes. Use remaining
four screws and four washers to complete
installation of bed and mounting bracket.
Insert washers over lower four screws.
All SIX screws and four washers must be
properly mounted to the chassis.
Step 4. Install Liner Dispenser
Ensure liner dispenser is free from
damage. Remove key, unlock, and open
liner dispenser lid. This will expose
liner dispenser mounting holes. Line
up dispenser mounting holes onto
chassis and secure with the four screws
provided. Close and lock the liner
dispenser door.
Step 5. Complete Installation
Inspect unit to ensure it opens and
closes smoothly. Clean gently with a
stainless steel cleaner, following the
manufacturer’s recommended cleaning
instructions. Clean work area. Give
Operator Kit and key to the facility
operator. Replacement parts and
additional liners can be purchased from
your local distributor or by calling Koala
at 888.733.3456 or 303.539.8300.
INSTALLATION INSTRUCTIONS
4