Kontron CP3002-RA User Manual

Page 25

Advertising
background image

CP3002-RC/CP3002-RA

Introduction

ID 1039-3625, Rev. 1.0

Page 1 - 9

P R E L I M I N A R Y

Integrated

Contro

ller

Graphics controller

High-performance 3D graphics controller integrated in the processor:

Supports resolutions up to 2048 x 1536 pixels @ 60 Hz

Dynamic Video Memory Technology (DVMT)

Interfaces

CompactPCI

Compliant with CompactPCI Specification PICMG

2.0 R 3.0:

System controller operation

32-bit, 33 / 66 MHz PCI master interface with dedicated PCIe-to-PCI
bridge

3.3 V or 5 V signaling levels (universal signaling support)

Support for up to four peripheral slots (4x REQ/GNT signals)

Rear I/O

The following interfaces are routed to the rear I/O CompactPCI connector J2:

1 x COMA (RS-232 signaling)

1 x COMB (RS-422 / RS-232 signaling)

2 x USB 2.0

1 x VGA analog port

4 x 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces

2 x SATA

5 x GPIs and 3x GPOs (LVTTL signaling)

Back-up voltage (3.3 V)

Interfaces

Gigabit Ethernet

Up to four 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
based on the Intel® 82580EB Quad Gigabit Ethernet controller:

Four ports on the rear I/O

Automatic mode recognition (Auto-Negotiation)

Automatic cabling configuration recognition (Auto-MDI/X)

USB

Two USB 2.0 ports on the rear I/O interface

Serial

Two 16C550-compatible UARTs (RS-232/RS-422 signaling):

One RS-232 port on the rear I/O, COMA

One RS-422 / RS-232 port on the rear I/O, COMB

Serial ATA

Serial ATA Host Controllers integrated in the Intel® QM57 chipset:

Provide support for three SATA ports, one onboard and two on rear I/O

Data transfer rates up to 300 MB/s

High-performance RAID 0/1/5 functionality on all SATA ports

Sockets

Onboard Connectors

One 34-pin extension connector, J3, for SATA Flash module (SSD)

JTAG connector, J4

XDP-SFF (debug) connector, J6

CompactPCI Connectors J1 and J2

LE

Ds

Debug LEDs

Debug LEDs:

DLED0-3 (red / green): Onboard LEDs for debugging purposes

The DLEDs are located on the rear side of the board.
On the CP3002-RA, the DLEDs are visible on the front panel.

Table 1-1:

CP3002-RC/CP3002-RA Main Specifications (Continued)

FEATURES

SPECIFICATIONS

Note ...
To operate the CP3002-RC/CP3002-RA, 3U CompactPCI back-
plane with maximum five slots and rear I/O support on the system
slot is required.

Advertising
This manual is related to the following products: