Introduction cp342 – Kontron CP342 User Manual
Page 26
Page 1 - 12
Doc.ID: 34938, Rev 1.0
Introduction
CP342
CUSTOMER SPECIFIC
P R E L I M A R Y
CP342-SFP
Controller
Intel® 82546GB, dual channel Gigabit Ethernet, lead free version
Ethernet
Two channels of Gigabit Ethernet: 1000 Mbit/s
Ethernet Interfaces
Two SFP cage interfaces on the front panel
LEDs
Three status LEDs per channel, integrated in the front panel, green
Boot Flash
Flash memory socket (PLCC32) available for up to 1 MB of removable Flash
memory for user-installed and programmed boot chip (Flash memory is optionally
available with the product)
Speed Configuration Gigabit Ethernet only
Signalling Voltage
3.3 volt (5 volt tolerant)
Plug & Play Design
No jumpers to be configured
Power Consumption
Source: 3.3 V: consumption: ca. 5.6 watts
Temperature Range
Operational:
0ºC to
+55ºC Standard
Storage:
-55ºC to +125ºC
Climatic Humidity
93% relative humidity at 40°C, non-condensing
Dimensions
160 mm L x 100 mm W (single height Eurocard)
Board Weight
ca. 145 g (with heatsink)
CP342-RIO
Controller
Intel® 82546GB, dual channel Gigabit Ethernet, lead free version
Ethernet
Two channels of three speed Ethernet: 10/100/1000 Mbit/s
Ethernet Interfaces
Backplane rear IO only on the J2 connector (requires rear IO capable backplane)
LEDs
Three status LEDs per channel, integrated in the front panel, green
Boot Flash
Flash memory socket (PLCC32) available for up to 1 MB of removable Flash
memory for user-installed and programmed boot chip (Flash memory is optionally
available with the product)
Speed Configuration Auto-negotiation for speed and switching
Signalling Voltage
3.3 volt (5 volt tolerant)
Plug & Play Design
No jumpers to be configured
Power Consumption
Source: 3.3 V: consumption: ca. 5.6 watts
Temperature Range
Operational:
0ºC to
+55ºC Standard
-40ºC to
+85ºC E2 (on request)
Storage:
-55ºC to +125ºC
Climatic Humidity
93% relative humidity at 40°C, non-condensing
Dimensions
160 mm L x 100 mm W (single height Eurocard)
Board Weight
ca. 145 g (with heatsink)
Table 1-2: Main Specifications (Continued)
TYPE
SPECIFICATIONS