Kontron AT8902M CLI - Manual (Page 132)

Routing Commands AT8902M
AT8902M CLI Reference Manual Page 3 - 18
3.5.2.1 no ip vrrp
Use this command in Interface Config mode to delete the virtual router associated with
the interface. The virtual Router ID,
<vrid>
, is an integer value that ranges from 1 to
255.
Format
no ip vrrp
<vrid>
Mode Interface Config
3.5.3 ip vrrp mode
This command enables the virtual router configured on the specified interface.
Enabling the status field starts a virtual router. The parameter
<vrid>
is the virtual
router ID which has an integer value ranging from 1 to 255.
Default
disabled
Format
ip vrrp
<vrid>
mode
Mode Interface Config
3.5.3.1 no ip vrrp mode
This command disables the virtual router configured on the specified interface.
Disabling the status field stops a virtual router.
Format
no ip vrrp
<vrid>
mode
Mode Interface Config
3.5.4 ip vrrp ip
This command sets the virtual router IP address value for an interface. The value for
<ipaddr>
is the IP address which is to be configured on that interface for VRRP. The
parameter
<vrid>
is the virtual router ID which has an integer value range from 1 to
255. You can use the optional
[secondary]
parameter to designate the IP address as a
secondary IP address.
Default
none
Format
ip vrrp
<vrid>
ip
<ipaddr> [secondary]
Mode Interface Config
3.5.4.1 no ip vrrp ip
Use this command in Interface Config mode to delete a secondary IP address value
from the interface. To delete the primary IP address, you must delete the virtual router
on the interface.
Format
no ip vrrp
<vrid> <ipaddress> secondary
Mode Interface Config
3.5.5 ip vrrp authentication
This command sets the authorization details value for the virtual router configured on a
specified interface. The parameter
{none | simple}
specifies the authorization type
for virtual router configured on the specified interface. The parameter
[key]
is