Kontron AT8050 - Manual (Page 49)

33 AT8050
www.kontron.com
3.3.2 Installing Memory
On an anti-static plane, place the board so that you
are facing the front plate connectors
Remove the memory protection top cover.
Insert the memory module into any available
socket, aligning the notches on the module with the
socket’s key inserts.
1- Insert the memory module in the connector using
your thumbs.
2- Eject partially the memory module, using the
connector latches while applying some pressure on
the top to avoid the full removal of the modules.
3- Fully Reseat the modules in the connector using
your thumbs.
4- Repeat steps 2 and 3 a second time.
5- Push down the memory module until the
retaining clips lock on each side.
Repeat these steps to populate the other socket.
To remove a memory module from a socket, push
sideway the retaining clips on each side of the
socket, to release the module. Pull out the memory
from the socket.