2 onboard interconnectivity, 1 onboard connectors, 3 board hot swap and installation – Kontron AM4530 User Manual

Page 28: 1 installing an amc, 2 removing an amc, Onboard connectors, Installing an amc, Removing an amc, Table 3-2 onboard connectors

Advertising
background image

15

AM453x

www.kontron.com

3.2

Onboard Interconnectivity

3.2.1

Onboard Connectors

Table 3-2: Onboard Connectors

3.3

Board Hot Swap and Installation

Some precautions must be taken when connecting or disconnecting a board to:

1 Rail guides must be installed on the enclosure to slide the board to the backplane.

2 Do not force the board if there is mechanical resistance while inserting the board.

3 Use extractor handle to disconnect and extract the board from its enclosure.

3.3.1

Installing an AMC

To install an AMC:

1 Remove the AMC filler panel.

2 Carefully engage the AMC into the card guide. Push the AMC until it fully mate with it's connector. Secure

the AMC handle to the locking position.

3 In normal condition, the blue LED shall turn ON as soon as the AMC is fully inserted. It will turn OFF at the

end of the hot swap sequence.

3.3.2

Removing an AMC

To remove an AMC:

1 Open the AMC handle.

2 The blue LED will start blinking; wait until it is solid blue.

Description

Connector

Comments

AMC Connector

J2

AMC Connector

SATA Connector

J3

SATA / SSD Disk Connector

Serial Port Connector

J5

RJ45 Serial Port Connector

WARNING

Always use a grounding wrist wrap before installing or removing the board from a
chassis.

Advertising