The uefi shell am5030 uefi bios – Kontron AM5030 uEFI User Manual
Page 64
The uEFI Shell
AM5030 uEFI BIOS
Page 58
ID 1037-1209, Rev. 1.0
P R E L I M I N A R Y
SETTINGS:
fru [<Fru device ID>]:
Displays FRU data
Options:
Fru device ID:
Numeric FRU device ID. 0 if FRU is omitted. FRU
device 0 is the baseboard’s own FRU.
ipmb:
Displays IPMB bus settings
ipmb redundant:
Switch IPMB bus to redundant mode
ipmb single:
Switch IPMB bus to single mode
Irq <number>:
Display/Set the IRQ number of the KCS interface
Options:
0:
KCS uses no IRQ
10:
KCS uses IRQ 10
11:
KCS uses IRQ 11
The board must be reset for the settings to apply.
Mode <mode>:
Display/Set the IPMI controller operating mode
Options:
bmc:
IPMI controller operates in BMC mode
smc:
IPMI controller operates in SMC mode
Net:
Set Serial-over-LAN parameters
Sel:
Display system event log
Note: The AM5030 does not have a system event log.
Sensor list|read:
Show board sensor data
Options:
list:
Display an overview of all available board sensors
read:
Display specific sensor data
Raw [<bytes> <...>]:
Execute raw IPMI command
Syntax:
raw [NetFn] [LUN] [COMMAND] ...
Rawsendmesage [<bytes> <...>]:
Bridge raw IPMI command
Syntax:
raw [rsSA] [Channel] [NetFnm] [Lun] [function]...
Info:
Display IPMI firmware information
kipmi