Kontron AM4140 U-Boot Bootloader - Manual (Page 37)

AM4140 U-Boot Bootloader U-Boot Usage
ID 1052-0281, Rev. 1.0 Page 37
P R E L I M I N A R Y
6.2.2.2 sconf select
To change the setting, invoke the “sconf select” command.
Example:
6.2.2.3 sconf set
The setting of the chosen base configuration can be changed via the “sconf set” command. If
the “sconf set” command is invoked without parameters, all changeable options are shown. In
the following example, first, all possible settings are shown, and then the SerDes port 1 is
changed from rear to the front Ethernet connector J2 (GbE B). In certain “sconf base select”
configurations the ETH front PHY is not available anymore. In such cases it is possible to
switch the AMC SerDes port 1 as copper port to the front panel connector J2 (GbE B).
=> sconf select 5
New base configuration 5
=>
=> sconf set
Board’s Port Configuration:
Option / Setting | Value # command, option <and parameter>
---------------------------------------------------------------
Port 1 : rear # sconf set port1 <rear | front>
SRIO Sys.Size : small # sconf set srio <small | large>
SRIO mode : agent # sconf set srio <agent | host>
AMC Port Activation / Forced settings (ignoring E-Keying):
Option / Setting | Value # command, option <and parameter>
---------------------------------------------------------------
Port 4 : auto # sconf set port4 <auto | disable | enable>
Port 8 : auto # sconf set port8 <auto | disable | enable>
FCLKA : auto # sconf set fclk <auto | in | out | local>
=>
=> sconf set port1 front
=>