3 firmware upgrade - “ipmitool fwum, Fru information, Firmware upgrade - “ipmitool fwum – Kontron AM4140 IPMI Firmware User Manual

Page 32: Ipmi firmware am4140

Advertising
background image

IPMI Firmware

AM4140

Page 32

ID 1051-8188, Rev. 1.0

P R E L I M I N A R Y

5.3.3

Firmware Upgrade - “ipmitool fwum”

The “ipmitool” version 1.8.9 doesn’t support HPM.1 correctly. Tool versions prior to this do not
support HPM.1 at all.

The firmware upgrade procedure starts with the download of the binary firmware file using, for
example, the following command:

The next step is the activation of the newly downloaded MMC firmware. This is done using

:

Detailed information about the active and inactive firmware images can be obtained using the
following command:

To perform a manual rollback to the previously good firmware image, use the following com-
mand:

6.

FRU Information

The MMC provides 4 kB of non-volatile storage space for FRU information. Some of the data
stored there, such as the Module Current Requirements record or E-Keying information (refer
to AMC.0 specification for details), are mandatory for module functionality in an ATCA/AMC en-
vironment.

Please note that missing FRU information possibly will prevent the AMC module from being ac-
cepted by the carrier controller during the hot swap process, and the module will possibly not
receive payload power.

Full low-level access to read or write a module's FRU information is provided by regular IPMI
FRU device commands. Please be careful when writing FRU information directly using stan-
dard IPMI commands. Damaging the FRU information may lead to a non-working payload.

ipmitool fwum download <Binary_FWFile>.bin

ipmitool fwum upgrade

ipmitool fwum status

ipmitool fwum rollback

Note ...

The FRU data can be read and upgraded via the U-Boot “fru” command. For
further information, refer to the AM4140 U-Boot Bootloader User Guide.

Advertising