Kontron MSM800BEV V101 BIOS - Manual (Page 39)

Geode LX800 / LX900 / BIOS
www.kontron.com 37
7.3.2 Mother Board Device Configuration
The Mother Board Device configuration contains the only sub menu system in the setup screens. The choices are:
Drive Configuration
The drive configuration screen determines the setup for the hard drives, floppy, CD-ROM and flash configurations.
Hard Drive Configuration:
IDE BIOS Support: Allows the configuration of the IDE channel. The options are Enabled or Disabled.
80-Conductor Cable Sense: Selects the GPIO that is connected to the IDE-PDIAG sense. The options
are: GPIO 00-17; None (disabled); Force to 40pin conductor cable; or Force to 80pin
conductor cable.
DMA/UDMA BIOS Support: This enables DMA/UDMA timings. The options are Enabled and Disabled.
Max mode for Drive 1 or 2: This enables the transfer mode. The options are: Auto; PIO 0-4; MDMA 0
or 1; and UDMA 0-4.
Floppy Configuration: Allows the Floppy to be Enabled or Disabled.
CDROM Configuration: Allows the CD-ROM to be either Enabled or Disabled.
Flash Configuration: Allows the use of a flash device over the IDE; options are Enabled or Disabled.
Chip Select 0-3:
Size: Allows the configuration of the flash chips to be Disabled or set to the sizes 8K/16B, 16K/32B,
128K/64B, 512K/128B, 4M/256B, 8M/256B or 256M/256B (in the form MemorySize / I/O
size).
Base: Allows the configuration of the base address. The options are PCI defaults, D2000, D4000 or
D6000.
Type: Allows the selection of the flash memory type. The options are NOR Mem, or NAND I/O.